Armor SCU85

The Armor Epoxy SCU85 is a single component 1K 85% solids no odor air cure urethane. It is an ideal topcoat for metallic pigment, viny flakes, countertops, and more. It offers a smooth, lasting gloss finish and offers superior hardness, chemical resistance, and UV stability.

• User friendly, easy to apply
• Low VOC, no odor
• UV stable, non-yellowing
• Offers superior hardness
• Offers superior chemical and liquid resistance
• Ideal topcoat for metallic pigment and vinyl flake systems

Looking for a complete viny flake coating system? We can help!

• PRIMER: Armor MB100
• COLOR: Armor 100% Epoxy (pre-tinted)
• CHIPS: FULL BROADCAST Vinyl Flakes
• TOP-COAT: Armor SCU85

For complete application instructions, please refer to the Technical Data Sheet published on FoundationArmor.com.

Over Existing Coating: Up to 200 – 350 ft² per gallon

Over Media Broadcast Systems: Up to 175 – 225 ft² per gallon        

Coverage rates will vary depending upon surface porosity and texture, and application method. Excessive build up should be avoided.

The Armor SCU85 is designed for use on interior concrete floors.

It is also a great color base-coat if you are considering an epoxy flake system.

If you are using the Armor Epoxy Flake System, here is how to apply the complete coating system:

• Primer Coat: Apply the ARMOR MB100 Primer-coat. Allow 8-24 hours to cure before applying the epoxy base color coat.
• Color Base Coat: Apply ARMOR EPOXY100 color epoxy basecoat to floor.
• Broadcast Vinyl Flakes: Immediately after applying the EPOXY100, wearing spike shoes, broadcast vinyl flakes at a rate of 14lbs – 18lbs per 100ft² or until the epoxy completely covered (until the base color coat is no longer visible).  Allow the floor to cure for 10-14 hours.
• Test Flakes: Test the floor to verify the chips are not moving and the epoxy is set up enough to prepare the floor for the urethane topcoat. Simply press your thumb down on the chips and slowly twist your thumb to verify the epoxy below and the chips are not moving.
• Scrape and Clean Floor: Using a flat blade scraper, at a low angle, glide the scraper across the surface removing all vertically bonded flakes and all other residual unbonded vinyl flakes. After scraping the floor sweep and vacuum the floor to ensure only bonded vinyl flakes remain before applying the urethane topcoat.
• Top Clear Coat: Apply a urethane topcoat (ARMOR SCU85, UTX60 Gloss) by pouring the material in ribbons and spread with a flexible magic squeegee, followed by back-rolling with a 3/8” nap roller. Do not allow the urethane topcoat to puddle and do not over-roll the surface as it is essential to ensure a uniform film formation over the surface.  Visual indicators should be: light, uniform liquid appearance on the surface with no puddling   Note: Make sure the roller is fully saturated before rolling.