Armor Concrete Wax - Matte

The Armor Concrete Wax-Matte is a water-based acrylic floor wax designed to enhance and seal interior concrete floors. It can be applied to unsealed smooth concrete surfaces, and over acrylic, epoxy, and urethane coatings. It is a fantastic easy-to-apply sacrificial coating that offers superior protection against surface abrasion and scuffing. The Armor Concrete Wax-Matte is perfect for applications in need of a quick and easy solution for protecting and refreshing concrete floors.

• PROFESSIONAL GRADE CONCRETE FLOOR WAX: The Armor Wax-Matte will provide a durable, non-yellowing, professional-grade matte finish that offers superior protection against abrasion and scuffing in commercial and residential applications.
• ATTRACTIVE MATTE FINISH: The Armor Wax-Matte is designed to instantly refresh interior concrete floors and dull concrete coatings with a matte finish.
• READY TO USE: The Armor Wax-Matte can be applied to a properly cleaned and prepped surface with a microfiber mop. One gallon covers up to 800-1,000 square feet per gallon.
• WATER-BASED: The Armor Wax-Matte is water-based, making it a preferred wax for interior surfaces.
• VERSATILE: The Armor Wax-Matte is designed for use on interior concrete floors. It can be used on unsealed smooth concrete, and concrete that has been sealed with an acrylic, epoxy, or urethane coating.

The Armor Concrete Wax can be applied with a microfiber mop. For a consistent finish, apply two coats spaced 1-3 hours apart.

Surface Preparation

The Armor Concrete Wax should be applied to a completely clean and dry surface. If the surface was wet during the cleaning process, allow 24 hours to dry. While the Armor Concrete Wax can be applied to unsealed concrete, and over most coatings, a test area is always suggested to verify compatibility and bonding.

If applying over a newly sealed surface, allow at least 7-10 days for the newly sealed surface to fully cure before applying wax. Applying wax to a newly sealed surface too soon could result in blushing of the wax.

Application

Using a  microfiber mop, apply at a rate of roughly 800-1000 square feet per gallon. The Armor Concrete Wax is designed to be applied in thin coats, it is not a high build coating. Apply wax in one direction to ensure a uniform finish. Do not puddle.

Allow 1-3 hours to dry and repeat with a second coat. Additional coats may be applied 1-3 hours apart until desired finish has been achieved.

Spray buffing and burnishing is not recommended with the matte wax, as it can create an inconsistent finish.

For in-depth up-to-date application instructions, please refer to the Technical Data Sheet and Safety Data Sheet for this product. Documents, videos, and customer photos can be found HERE.

Up to 800-1,000 square feet per gallon in one coat.

Coverage will vary depending on porosity, surface condition, application method, and the amount of material applied by the applicator. The above coverage rates are estimates and will vary. Two coats are suggested for even coverage and appearance.

The Armor Concrete Wax is designed for interior concrete floors. It can be applied to unsealed concrete floors, as well over most acrylic, epoxy, or urethane coatings.

Common Applications:

• Garage floors
• Warehouse, retail, restaurant, and office floors
• Basement floors and living area floors